C221520, Base plate 4-fold HCP, 200 mm, without bores

C221520

For installation on a machine table.

Without mounting bores

  • Centre distance 200 mm
  • Material: steel, heat pre-treated and ground
  • Nipple is incl. in scope of delivery
  • with 4 chucks C220000
  • Required drawbar set S812100
EDM-MILLING

Drawing

C221520

Facts

  • Repeat accuracy of the devices and workpieces < 0.005 mm
  • Mechanical clamping by spring force
  • Hydraulic release and lift-off of the devices
  • Hydraulic pressure 30 to 70 bar
EDM - Milling
EDM - Milling
System-3R
Feature

Application

Technicality

Reference surfaces on the base plates

Baseplate-references

The standard Delphin base plates feature a reference bore at the centre of the base plate. It can be used to orientate the base plate approximately to the centre (± 0.025 mm).
Subsequent alignment at an angle uses a reference surface on the rear side.
As soon as the base plate has been approximately orien-tated, the base plate can be aligned precisely using the conical centring lugs of the chucks.