Seeing is believing. A case in point.


Here are two identical Suspension Arms made out of Titanium. Both have been machined from solid using 0.25mm diameter brass wire on our EDM machines.

PART A was machined using one of our older EDM machines (ROBOFIL 290); PART B was machined using one of our latest models - the CUT 300 Sp.

Now take a look at the differences in cycle times achieved using both machines. Then look at the different surface finishes realised by both machines. And finally look at the cost savings achieved when machining this part using our latest EDM technology. We think you’ll be impressed.

CUT UPGRADE case study

Shireen Khanum
Business Development
GF Machining Solutions Ltd
North View
CV2 2SJ Coventry
West Midlands
United Kingdom

shireen dot khanum #at# georgfischer dot com

About GF Machining Solutions